BRP Evinrude E-Tec Series Installation Manual page 61

same path to the starboard side of the powerhead.
Secure all cables with clamps.
1. Anchor points
NOTICE
After installation, make sure there
is enough clearance for all cables to avoid
binding or chafing through all engine steering
and tilting angles.
Control Cable Installation
Refer to Control Cable Identification on p. 51.
Remove control cable trunnion covers and cab le
attachment hardware.
1
1. Trunnion covers
Shift Cable Installation and Adjustment
Place t he s hift ca ble on t he sh ift l ever p in and
install the washer and retainer clip. Refer to Cable
Retainer Clip Installation on p. 51.
Do not bend or deform clip.
IMPORTANT:
EVINRUDE E-TEC 60° V MODELS 115–200 HP
Make sure the remote control, gearcase, shift link-
age, and shift cable are in NEUTRAL.
Hold the shift linkage in NEUTRAL.
Push and p ull on the shift cable and observe the
1
cable slack. Hold the casing guide in the center of
the slack.
Adjust shif t cable trunn ion to align with center of
the trunnion block. Pla ce cable trun nion in tru n-
nion block.
Install trunnion cover and screw. Tighten screw to
a torque of 60 to 80 in. lbs. (7 to 9 N·m).
004949
1
1. Shift cable retainer clip and washer
2. Shift cable trunnion
Throttle Cable Installation and Adjustment
With remote control lever in NEUTRAL, pull firmly
on throttle cable casing to remove slack.
Place throttle cable on throttle lever pin and install
washer and retainer clip. Refer to Cable Retainer
Clip Installation on p. 51.
1
004955
1. Throttle cable retainer clip and washer
OUTBOARD RIGGING
2
004956
004957
59
3