Whirlpool duet GGW9200L Series Job Aid page 40

7. To remove the drive motor:
a) Remove the wires from the thermal
fuse and thermistor terminals (see the
photo at the bottom of the previous
page).
b) Remove the two hex-head screws from
the blower cover (see the previous page)
and remove the cover.
c) Reach around to the back of the drive
motor and attach a 7/8" open-end
wrench over the hex-end of the motor
shaft, and a ratchet with a 1/2" drive on
the blower wheel hub.
d) Turn the blower wheel clockwise (shown
by the "REMOVE" arrow that is em-
bossed on the front of the wheel ) and
remove the wheel from the motor shaft.
7/8" Open-End
Wrench
Ratchet w/ 1/2"
Drive
Blower Wheel
REMOVE
1/2" Drive
TIGHTEN
e) Remove the three hex-head screws
from the blower housing and remove it.
Housing Screw
(1 of 3)
f) Reach around behind the drive motor
and push the idler wheel arm to the left,
then remove the tension, and remove
the belt from the idler pulley.
4-8
Blower Housing
Remove Belt
From Idler Pulley
Push To Left