Whirlpool duet GGW9200L Series Job Aid page 29

STATUS LIGHTS
The Status indicator lights show the progress
of the dryer. Each of the lights indicate as
follows:
Status
Sensing
Wet
Damp
Cool Down
Cycle Complete
Sensing
When the dryer is first turned on, the Sensing
light glows until a wet item is detected.
• In an Automatic Cycle, if a wet item has not
been detected within 10 minutes, the Sens-
ing light will turn off, and the dryer will shut
down.
• In a Manual Cycle, if a wet item is not
detected after 10 minutes, the Wet light
turns on, and the selected cycle continues.
Wet
The Wet light will turn on when a wet item has
been detected in the dryer. The Wet light will
remain on until:
• The damp dry point is reached in an Auto-
matic Cycle.
• The dryer enters the cool down period in a
Manual Cycle.
Wrinkle Shield
Control Locked
Damp
The Damp light indicates that the load has
reached a damp dry level.
NOTE: The Damp light is not used with Manual
Cycles.
Cool Down
The Cool Down light glows during the cool
down part of the cycle. Laundry is cooling down
for ease in handling.
Cycle Complete
This light glows when a drying cycle is finished.
If the Wrinkle Shield feature has been selected,
the Wrinkle Shield feature indicator light will
also be on.
The Cycle Complete light turns off 1 hour after
the end of a drying cycle (including the Wrinkle
Shield cycle of 2 hours), when Pause/Cancel is
pressed, or when the door is opened.
Wrinkle Shield Feature
The Wrinkle Shield feature light glows when
this option is selected. This indicator stays on
with the Cycle Complete light.
Control Locked
The Control Locked light glows when this op-
tion is enabled.
Indicator Lights
Other indicator lights on the control panel,
show Cycle, Temperature, and End Of Cycle
Signal settings that are selected.
The time display will indicate the estimated or
actual time remaining in a cycle.
3-3