Removing The Thermal Fuse, Thermistor, Drive Motor, & Belt Switch - Whirlpool duet GGW9200L Series Job Aid

REMOVING THE THERMAL FUSE, THERMISTOR,
NOTE: Sharp edges may be present.
1. Turn off the gas to the dryer and discon-
nect the electrical power.
2. Open the dryer door and remove the lint
filter screen, then close the door.
Lint Filter Screen
3. Remove the two hex-head screws from
the bottom flange of the toe panel. Pull the
panel out at the bottom, pull down, and
remove the panel.
Toe Panel
Toe Panel Screws
DRIVE MOTOR, & BELT SWITCH
4. Remove the hex-head screw from the lint
duct bracket and remove the bracket.
Lint Duct Bracket & Screw
5. Remove the two hex-head screws from
the lint duct and remove the duct.
6. To remove the thermal fuse or ther-
mistor:
a) Remove the two wires from the termi-
nals.
b) Remove the two hex-head screws.
2 Cover Screws
Continued on the next page.
4-7
Lint Duct Screws
Thermal Fuse
(2 Screws)
Thermistor
(2 Screws)
Screws
Blower Cover