Advertisement
ISO DDIN radio provision
1. Cut and remove the center bar from the
radio housing. (Figure A)
2. Attach the ISO DDIN brackets to the
inside opening of the radio housing
assembly. (Figure B)
3. Slide the radio into the radio housing
assembly, then secure using screws
supplied with the radio. (Figure C)
4. Snap the ISO DDIN trim plate onto the
front of the radio housing assembly.
(Figure C)
5. Locate the factory wiring harness
and antenna connector in the dash.
Complete all necessary connections
to the radio and vehicle. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio and vehicle for proper operation.
6. Reassemble the dash in reverse order of
disassembly.
KIT ASSEMBLY
(Figure A)
(Figure B)
(Figure C)
REV. 6/25/2019 INST99-8222
7
Advertisement
