Advertisement
ISO DDIN radio provision
1. Attach the panel clip provided onto the
radio housing (front).
2. Secure the radio brackets to the radio
housing (front) using (4) #8 x 3/8"
Phillips screws provided. (Figure A)
3. Slide the radio into the bracket/housing
assembly from the back, then secure
it to the assembly using the screws
supplied with the radio. (Figure B)
4. Secure the radio housing (rear) to the
radio assembly using (4) #4 x 3/8"
Phillips screws provided. (Figure C)
KIT ASSEMBLY
(Figure A)
(Figure B)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra
and/or Axxess. Test the radio for
proper operation.
6. Secure the radio assembly to the dash
using the (4) factory screws.
7. Reassemble the dash in reverse
order of disassembly to complete the
installation.
(Figure C)
REV. 6/21/2019 INST99-7392B
5
Advertisement
