Extron electronics DTP2 CrossPoint 82 User Manual page 71

X8@ = Playback state
X8#
= Repeat
X8$ = Playback delay
X8% = Configuration type
X8^ = Number of open connections
X8& = IP address
X8*
= Gateway IP address
X8( = Subnet mask
X9) = Hardware (MAC) address
X9! = Password
NOTE: The initial factory configured passwords for all accounts on this device
have been set to the device serial number. Passwords are case sensitive. In the
event of an absolute system reset, the passwords are reset to no password.
X9@ = Default unit name
X9# = Subnet mask in CISG
commands
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • SIS Configuration and Control
0
= Stop or stopped
1
= Play or playing
0
= No
1
= Yes
NOTE: Setting the repeat mode to
continuous playback causes play to stop after the
end of the current iteration.
Number of seconds to wait before the audio file repeats
X8# 1
(valid only if = [repeat]).
1 300
through (1-300 seconds delay between audio
playbacks)
0
= No delay
0
= IP configuration (ip.cfg)
2
= Unit-specific parameters (box.cfg)
0-<
maximum number of open connections
nnn.nnn.nnn.nnn
Format
192.168.254.254
Default =
Leading zeros in each of the four octets are optional in
setting values, and are suppressed in returned values.
nnn.nnn.nnn.nnn
Format
0.0.0.0
Default =
Leading zeros in each of the four octets are optional in
setting values, and are suppressed in returned values.
nnn.nnn.nnn.nnn
Format
255.255.255.0
Default =
Leading zeros in each of the four octets are optional in
setting values, and are suppressed in returned values.
00-05-A6 xx-xx-xx
-
• Length is 1-128 characters.
• All human-readable characters are allowed except
|
.
• The password cannot be a single space.
• Passwords are case-sensitive.
• A user password cannot be assigned if no
administrator password exists. An
returned.
• If the admin password is cleared, the user password
is cleared as well.
Combination of the model name and the last three
hexadecimal character pairs of the unit MAC address
(Example:
DTP2-CrossPoint-82-IPCP-SA-15-9E-B0
Prefix representing subnet mask bits (subnet mask value
in CISG commands).
/24
Default = , which represents the default subnet mask,
255.255.255.0.
0
during
>
E14
error code is
)
63