Rack Mounting - Planet HPOE-1200G User Manual

2.2.2 Rack Mounting

To install the PoE Injector Hub in a 19-inch standard rack, follow the instructions described below.
Step 1: Place your PoE Injector Hub on a hard flat surface, with the front panel positioned towards your front side.
Step 2: Attach a rack-mount bracket to each side of the PoE Injector Hub with supplied screws attached to the package.
Figure 2-2-1 shows how to attach brackets to one side of the PoE Injector Hub.
You must use the screws supplied with the mounting brackets. Damage caused to the parts by
using incorrect screws would invalidate the warranty.
Step 3: Secure the brackets tightly.
Step 4: Follow the same steps to attach the second bracket to the opposite side.
Step 5: After the brackets are attached to the Injector, use suitable screws to securely attach the brackets to the rack, as
shown in Figure 2-2-2.
Step 6: Proceed with steps 4 and 5 of session 2.2.1 Desktop Installation to connect the network cabling and supply
power to your PoE Injector Hub.
User's Manual of POE-1200G / POE-2400G / HPOE-1200G / HPOE-2400G
Figure 2-2-1: Brackets attaching to the PoE Injector Hub
Figure 2-2-2: Mounting the PoE Injector Hub in a Rack
18