Using Device Configuration Utility - Campbell CELL205 Product Manual

7. When new module firmware is available you will see a red notification in the Celllar
Modem field of the Status Tab. To begin the update process, click the red Start Cellular
Module OTA Update button.
D.2 Using Device Configuration Utility
NOTE:
This section applies to modules set up in integrated PPP mode which requires data logger
operating system 03.00 or later for the CR1000X, 09.00 or greater for the CR6 series, and 08.00
or later for the CR300 series.
1. Connect the Cellular antenna.
2. Connect the Diversity antenna, if used. (Not required. See
3. Connect your data logger to the CELL200-series module RS-232 or CS I/O port. See
and connections
4. If not connecting through CS I/O, provide power to the CELL200 series.
5. Connect a USB cable between your data logger and computer.
6. Connect to your data logger by using Device Configuration Utility.
(p. 25).
Antenna connections
CELL200-Series 4G LTE Cellular Module
(p. 29).)
Wiring
82