Use this mode when the module is behind a cellular provider firewall and it has a private dynamic
IP address. This mode requires the receiving TCP/IP connection be on a public static IP address,
on the same private cellular network, DNS name or there be a hole in the firewall.
NOTE:
Instructions in this section assume that you have established cellular service and the SIM card
has been installed as described in
6.4.4.1 Configure CELL200 series
To set up the CELL200 series in serial server mode:
1. Connect a USB cable between your module and computer.
2. Connect the Cellular antenna.
3. Connect the Diversity antenna, if used. (Not required. See
4. Open a web browser and go to: www.cell.linktodevice.eu/.
TIP:
If your computer does not respond to the DNS server correctly, browse to 192.168.86.1.
5. On the Settings tab, enter the APN provided by your cellular provider.
6. On the General tab, set Mode to Serial Client.
QuickStart (integrated mode)
CELL200-Series 4G LTE Cellular Module
(p. 8).
Antenna connections
(p. 29).)
44