Bit Allocation And Dip Switch Settings - Omron C200HX Operation Manual

Analog Timer Unit Programming

4-13-2 Bit Allocation and DIP Switch Settings

Timer Range Setting
Selecting Internal/External
Timer SV Setting
Refer to the Analog Timer Unit's Operation Manual for details on switching
between internal and external timer SV settings, connecting a variable resistor,
and switch settings.
Timer Start Input
Bits 08 to 11 of n
Completion Flags
Timer Start Input
Time-up Output
Timer interval
The following table shows the use of the word (n) allocated to the Analog Timer
Unit. This word address depends upon the slot in which the Unit is mounted.
Bit I/O class
00 Output p Timer 0 Set Bit
01 Timer 1 Set Bit
02 Timer 2 Set Bit
03 Timer 3 Set Bit
04 Timer 0 Stop Bit
05 Timer 1 Stop Bit
06 Timer 2 Stop Bit
07 Timer 3 Stop Bit
08 Input p Timer 0 Completion Flag
09 Timer 1 Completion Flag
10 Timer 2 Completion Flag
11 Timer 3 Completion Flag
12 to 15 --- Not used.
Set the timer range with the upper DIP switch on the front of the Unit. Each tim-
er's range can be set independently.
Range g
Timer 0
Pin 8
0.1 to 1 s OFF
1 to 10 s ON
10 to 60 s OFF
1 to 10 minutes ON
Select internal or external setting with the lower DIP switch on the front of the
Unit.
Setting Timer 0 (pin 4)
Internal ON
External OFF
Function
ON when timer is set.
OFF: Enable timer operation
ON S ON: Stop timer operation
ON when timer has timed out.
---
Timer 1
Pin 7 Pin 6 Pin 5 Pin 4
OFF OFF OFF OFF
OFF ON OFF ON
ON OFF ON OFF
ON ON ON ON
Timer 1 (pin 3) Timer 2 (pin 2)
ON ON
OFF OFF
Section 4-13
Timer Set
Bits
(Bits 00 to
03 of n)
Time-up
Output
Comments
p
i i
Timer 2 Timer 3
Pin 3 Pin 2 Pin 1
OFF OFF OFF
OFF ON OFF
ON OFF ON
ON ON ON
Timer 3 (pin 1)
ON
OFF
131