Supermicro X11SRi-IF User Manual page 91

Update IPMI LAN Configuration
Select Yes for the BIOS to implement all IP/MAC address changes at the next system boot.
The options are No and Yes.
*If the feature above is set to Yes, the following features will become available for
configuration:
IPMI LAN Selection
This feature displays the the type of the IPMI LAN. The default setting is Dedicated.
VLAN
Select Enabled to enable IPMI VLAN function support. The default setting is Disabled.
VLAN (Available when VLAN above is set to Enabled)
Specifies the VLAN ID (Identifier) for which the access list has to be applied. This
value ranges between 0 and 4093. The default setting is 0.
Configure IPV4 Support
Configuration Address Source
This feature allows the user to select the source of the IP address for this computer. If
Static is selected, you will need to know the IP address of this computer and enter it to the
system manually in the field. If DHCP is selected, the BIOS will search for a DHCP (Dynamic
Host Configuration Protocol) server in the network that is attached to and request the next
available IP address for this computer. The options are DHCP and Static.
*If the feature above is set to Static, the following features will become available for
configuration:
Station MAC Address
This feature displays the Station MAC address for this computer. Mac addresses are six
two-digit hexadecimal numbers.
Station IP Address
This feature displays the Station IP address for this computer. This should be in decimal
and in dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This feature displays the sub-network that this computer belongs to. The value of each
three-digit number separated by dots should not exceed 255.
Gateway IP Address
This feature displays the Gateway IP address for this computer. This should be in decimal
and in dotted quad form (i.e., 172.31.0.1).
91
Chapter 4: UEFI BIOS