Acpi Settings - Supermicro X11SRi-IF User Manual

Super X11SRi-IF User's Manual
Port 0~3 Hot Plug
Set this feature to Enable for hot plug support, which will allow the user to replace a SATA
drive without shutting down the system. The options are Disabled and Enabled.
Port 0~3 Spin Up Device
When this feature is disabled, all drives will spin up at boot. When this feature is enabled,
it will perform Staggered Spin Up on any drive this option is activated. The options are
Disabled and Enabled.
Port 0~3 SATA Device Type
Use this feature to specify if the SATA port specified by the user should be connected to a
Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
Trusted Computing (Available when a TPM device is installed

and detected by the BIOS)
When a TPM (Trusted-Platform Module) device is detected in your machine, the following
information will be displayed.
•
Vendor Name
•
Firmware Version
Security Device Support
If this feature and the TPM jumper (JTPM1) on the motherboard are both enabled, the
onboard security (TPM) device will be enabled in the BIOS to enhance data integrity and
system security. Please note that the OS will not show the security device. Neither TCG EFI
protocol nor INT1A interaction will be made available for use. If you have made changes on
the setting on this feature, be sure to reboot the system for the change to take effect. The
options are Disable and Enable.

ACPI Settings


WHEA Support
Select Enabled to support the Windows Hardware Error Architecture (WHEA) platform and
provide a common infrastructure for the system to handle hardware errors within the Windows
OS environment to reduce system crashes and to enhance system recovery and health
monitoring. The options are Disabled and Enabled.
76