IBM TS7600 with ProtecTIER Software Upgrade Manual page 96

6. Upgrade the ESM level.
7. The upgrade process of the firmware and NVSRAM is now complete. Close
82
IBM System Storage TS7600 with ProtecTIER: Software Upgrade Guide
Note: During this activation, both A and B controllers are upgraded. When the
activation is completed, a New Firmware Detected window is displayed. Click
OK.
a. In the Manage Storage Subsystem window, click the Advanced button in
the top menu bar.
b. Select Maintenance → Download → ESM Firmware. The Download
Environmental (ESM) Card Firmware window is displayed.
c. In the Drive Enclosure section, select the enclosure to be upgraded.
d. In the ESM Firmware section, click the Select File button. A new window is
displayed. Type the path of the ESM and press Enter. The path might be
similar to the following: /home/service/offload/DS4k Storage Manager
v10.60.x5.17 for Windows 32-bit/DS4700. In the same window, select the
esm98D0.esm file from the Files section.
Note: The storage system firmware is located on the IBM System Storage
ProtecTIER Manager V3.1 DVD under a 10.60.x5.17 for Windows 32-bit
directory, DS4k Storage Manager v10.60.x5.17 for Windows 32-bit. It is
used on the TSSC Linux version as well, and the files are the same.
e. Click the OK button at the bottom of the window. The Download
Environmental (ESM) Card Firmware window is displayed.
f. Click the Start button in the Download Environmental (ESM) Card
Firmware window to start the ESM download process. A Confirm Download
dialog is displayed. Type yes and click OK to continue. This process takes
5-7 minutes for each enclosure. The Status column displays Transferring
until the process is complete. The enclosures can only be updated one at a
time.
g. Repeat substep 6c. through substep 6f. for each enclosure.
any open DS Storage Manager windows. Right-click the blue desktop of the
TSSC and select Logout.