Tssc Ip Addresses; Base Clusters And Additional Storage Component Ip Addresses - IBM TS7600 with ProtecTIER Software Upgrade Manual

TSSC IP addresses

Table 13. TSSC IP addresses
TSSC
TSSC
TSSC
TSSC IP addresses from frame-to-frame
A single frame is ten IP addresses, and each node within a frame requires its own
set of ten IP addresses – from 0 to 9. If there are no attached devices/systems, the
first usable frame would be 10. For example:
v 172.31.1.10 - 172.31.1.19 would be considered frame 10
v 172.31.1.20 - 172.31.1.29 would be considered frame 20
v 172.31.1.30 - 172.31.1.39 would be considered frame 30...
v 172.31.1.240 - 172.31.1.249 would be considered frame 240
Table 14. Base Clusters and Additional Storage Component IP addresses
The TSSC IP address range changes from frame to frame, and each new frame increments by a multiple of 10. For
example, the first stand-alone frame range would be 10, and the second frame range would be 20.
If this is a clustered set of servers, the entry for the first server (A) will most likely be 10. For the entry for the
second server (B), you will also enter 10 for the frame number. The code will make the adjustment automatically
based on the answer you provide during the RAS package installation process that asks you if you are setting up
the second node. If you reply "Yes", the code will set the IP range for node 2 at 5 octets higher than what is set for
node 1 (server A). For example, if server A is set for 172.31.1.10 then server B will be set for 172.31.1.15.
Note: Depending upon the address ranges available on the TSSC, the IBM Service representative may have to use
ranges other than those shown here.
Component
Server
Server
Ethernet Port
External
Internal
Port
eth3
RSA or IMM
Default IP Address
N/A
172.31.1.1 (fixed, do not
change)
IP Addresses:
Stand-alone server -or-
Node A in a cluster
(the server located in the
lower part of the rack)
Examples:
For eth3,
172.31.1.x0
For RSA or IMM,
172.31.1.x1
Appendix D. IP address worksheet
Customer Assigned IP
Address
N/A
IP Addresses:
Node B in a cluster
(the server located in the
upper part of the rack)
Examples:
For eth3,
172.31.1.x5
For RSA or IMM,
172.31.1.x6
69