Installation; Removing Packaging Reinforcement; Opening The Transportation Locks; Appropriate Installation Location - Beko WMB 51031 PL PT Manual

3

Installation

Removing packaging
reinforcement
Tilt the machine to remove the
packaging reinforcement. Remove the
packaging reinforcement by pulling the
ribbon.
Opening the transportation
locks
C Transportation safety bolts must be
removed before operating the washing
machine! Otherwise, the machine will
be damaged!
1. Loosen all the bolts with a spanner until
they rotate freely ("C")
2. Remove transportation safety bolts by
turning them gently.
3. Fit the covers (supplied in the bag with
the Operation Manual) into the holes on
the rear panel. ("P")
C Keep the transportation safety bolts in
a safe place to reuse when the washing
machine needs to be moved again in
the future.
C Never move the appliance without the
transportation safety bolts properly
fixed in place!
Appropriate installation
location
Install the appliance in environments
which have no risk of freezing, in a
stable and level position.
C The floor must be capable of carrying
the load on it!
C If the washing machine and a drier
are placed on top of each other, their
approximate weight together may reach
180 kg when they are full.
Important:
• Do not place the appliance on top of
the power cable.
• Keep at least 1cm distance from the
edges of other furniture.
• Place the machine on a firm surface; do
not position it on a long pile rug or such
like surfaces.

Adjusting the feet

C Do not use any tools to loosen the lock
nuts. Otherwise, they can be damaged.
1. Manually (by hand) loosen the lock nuts
on the feet.
2. Adjust them until the machine stands
level and firm.
3. Important: Tighten all lock nuts up
again.
Connecting to the water
supply.
Important:
• The water supply pressure required to
run the machine must be 1-10 bar (0,1
– 1,0 MPa). Attach a pressure-reducing
valve if the water pressure is higher.
• Connect the special hoses supplied
with the machine to the water intake
valves on the machine. The hose
bearing the "red" sign (90°C max) is the
hot water inlet and the hose bearing the
40
EN