Configuring Ports - Planet FSD-1020 Manual

Operation 3-19
Figure 3.11 Peer to PeerMode.
Changing the system setting to PEER to PEER Mode from the Main:
UNIT CONFIG>BUFFER MODE><PEER_PEER >Press and Hold Enter

Configuring Ports

This device will encounter problems unless it is configured correctly, to match
the setting of remote sites. Fortunately, all the ports of Desktop Switch
FSD-1020 support Auto-Negotiation and all ports are configured in this mode.
In the Auto-Negotiation mode, it learns the setting of the opposite site and
configures itself to meet its counter part. For the 10M ports, the
Auto-Negotiation capability enables the auto-setting of the
Duplex-mode(whether Half or Full) depending on the remote device.
However, in rare conditions you should configure manually, such as when the
opposite site does not support Auto-Negotiate.
To configure a port, first select the port and then select the desired setting. The
speed setting is available only for ports 1~2. Ports 3~10 only support 10Mbps.
PORT SETTING>PORT SEL><setting>
When a setting is selected, an asterisk symbol ('*') will be added to the first
character of the string. Making it convenient to check what the settings for
these ports are, by just going through the sub menu of PORT SETTING,
without making any confirmation. When you see the item that begin with an
'*', the port is set in that mode.
While the AUTO-NEGO is set, the speed and duplex selection are no longer
FSD-1020 User's Manual