Door Removal - True TBR Series Installation Manual

TRUE
TBR | TDR SERIES
CABINET ADJUSTMENTS
SLIDE DOOR OPERATION – DOOR ADJUSTMENT

DOOR REMOVAL

– Before removing slide door, do not use the side latch.
STEP 1
Tension on the door cord is needed to execute these operation
instructions. Doors cannot be removed unless placed in specific
locations stated in these instructions.
STEP 2 – TWO DOOR UNITS:
centered on the cabinet. The door cannot be removed unless
it is centered (see image 1 for door channel openings, and
image 2 for centering door).
THREE DOOR UNITS: Slide the middle door to the right, so it
is centered with the left edge of the right door (see image 3).
– After centering the door, lift it up and tilt top of
STEP 3
door towards the back of the unit, so the rollers are out of the
top channel. Swing the bottom of the door out of the bottom
channel. Then remove the door and set it down (see image 4).
TWO DOOR UNITS SKIP TO STEP 6
– Slide left door to the right, so right edge lines up with
STEP 5
the end of the TRUE Logo located at the top of the door frame
(see image 6). Then lift door out of track same way as image 4.
Door cord will either be nylon cord or metal cable.
NOTE:
– Remove door cord from roller bracket. The black
STEP 6
plastic tab holding the door cord slides out the back
(see images 7 & 8).
– Let the door cord slowly retract back into the door
STEP 7
side channel.
– When reinstalling door, make sure door cord
STEP 8
grommet attaches to roller slot closest to pulley (see image 9).
TO ADJUST THE SLIDE DOOR
– After cabinet is installed in a final location and
STEP 1
correctly leveled, check for any openings when the slide doors
are completely closed. If there are any gaps/openings between
the closed doors and cabinet, the doors will need to be
adjusted.
– Using a 7/16" wrench or adjustable wrench and
STEP 2
1/8" Allen wrench, loosen roller and move along slotted hole.
After adjustment has been made tighten the roller into place.
(see image 10).
24
(CONT.)
Slide the front door so it is
1
CENTERED DOOR
2
3
4
5
truemfg.com