Cabinet Operation - True TBR Series Installation Manual

TRUE
TBR | TDR SERIES

CABINET OPERATION

STARTUP
The compressor is ready to operate. Plug in the cooler.
A.
Temperature controls are factory-set to give refrigerators
B.
an approximate temperature of 35°F (1.67) Allow unit to
function several hours, completely cooling cabinet before
changing the control setting.
Excessive tampering with the control could lead to service
C.
difficulties. Should it ever become necessary to replace
temperature control, be sure it is ordered from your
TRUE dealer or recommended service agent.
Good air flow inside your TRUE unit is critical. Be careful to
D.
load product so that it neither presses against the sides or
TEMPERATURE CONTROL & LIGHT SWITCH LOCATION
Light Switch on Glass Door Models
Inside top ceiling
Electronic Temperature Control
On the front of grill
FOR MORE INFORMATION
regarding a cabinet's general sequence of operation including
basic temperature control adjustments, please visit our website:
HTTPS://WWW. TRUEMFG.COM/SUPPORT/RESOURCE-LIBRARY
back wall, nor comes within 4" (101.6 mm) of the evaporator
housing. Refrigerated air off the evaporator coil must circulate
throughout the cabinet for even product temperatures.
If the unit is disconnected or shut off, wait five minutes
NOTE:
before starting again.
– Before loading product we recommend
RECOMMENDATION
you run your TRUE unit empty for two to three days. This allows
you to be sure electrical wiring and installation are correct and no
shipping damage has occurred. Remember, our factory warranty
does not cover product loss!
OPTIONAL FACTORY INSTALLED TRULUMINA LED
To change the display color of the TruLumina LEDs, toggle the light
switch off and then on. Repeat to cycle trough all available colors.
Leaving the light switch in the "off" position for 2 seconds will turn
off the lights.
truemfg.com
13