Setting The Analyzer Ip Address On The Management Port; Setting Up The Analyzer Security; Setting The Analyzer Name - Fluke OptiView Series Getting Started Manual

Setting the Analyzer IP Address on the Management Port

Select Setup | Management Port and either configure using DHCP, or enter the
IP address manually.

Setting Up the Analyzer Security

The Setup | Security screen provides analyzer security settings for packet capture,
remote access, and SNMP configuration.
The Setup | Ethernet screen allows you to select Receive only, do
not transmit frames, which turns off the analyzer transmit capability,
thus putting it on the network in silent mode. Turning off the analyzer
transmit capability disables activily querrying devices for name
resolving and other active tests such as Ping.
The analyzer's MAC address can also be changed in the Setup |
Ethernet screen for testing switch forwarding tables or ARP caches.

Setting the Analyzer Name

The OptiView Analyzer Name field allows you to change the default analyzer
name as seen by the network. This is especially useful when multiple analyzers are
connected to your network.
Setting Up the Analyzer Security
Note
Workgroup Analyzer
25