Nortel 1000 Manual page 135

Table 17
System messages displayed on the system terminal of TTY (cont'd.)
PLL lock lost
PWR messages
PWRxxxx HW SM UEM U
XMI000 loop message
XMI000 loop OIF: switched to prim/sec
XMI000 11 RSIG link lost - Reinitialized
XMI000 11 R71 CRC Error threshold exceeded
Table 18
Fiber Peripheral Controller selftest HEX codes
HEX code Test description
01
MPU confidence test
02
MPU internal RAM
03
Boot EPROM test
04
RAM test
05
MPU addressing mode test
06
ID EEPROM test
07
FLASH EPROM test (the programmable part)
08
Watchdog timer test
09
MPU timers test
0A DUART port A
0B DUART port B
0C A31 #1 external buffer
Nortel Communication Server 1000
Fiber Remote IPE Fundamentals
NN43021-554 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Replacing Fiber Remote IPE cards 135
FXPEC successfully locked on the signal from the
Electro-optical packlet identified by prim or sec.
PLL is in the process of trying to lock.
Where HW=PWSP (power supply), DCSP (DC battery),
SM=System monitor address (1-63) defined by the
FXPEC MMI port. UEM=0 for the main wall-mounted
cabinet and 1 for the expansion wall-mounted cabinet.
U=unit (not used).
This is the general format of MMI messages printed on
the system TTY. loop is the superloop number of the
FXNET and message is the text sent by the card.
Indication is that the span switched to primary or
secondary link.
Failure of R71 (RSIG) communication to the Fiber
Peripheral Controller card.