Maintenance; Navigation; Overview; Diagnostic Tools - Nortel 1000 Manual

.

Maintenance

Navigation

This section contains information on the following topics:
"Overview" (page 93)
"Diagnostic tools" (page 94)
"Using maintenance programs" (page 103)
"Isolating and correcting faults" (page 106)
"Fault isolation and correction" (page 108)
"Fiber Remote IPE fault isolation and correction" (page 110)
"Replacing Fiber Remote IPE cards" (page 125)

Overview

This section describes maintenance tools and procedures for identifying
Fiber Remote IPE faults, locating defective equipment, correcting problems
by fixing or replacing defective equipment, and verifying the operation of
Fiber Remote IPE after corrections or replacements have been made.
Fiber Remote IPE maintenance deals with two types of problems:
•
installation – created during the installation of an entire system with the
Fiber Remote IPE or during the addition of the Fiber Remote IPE to
an existing system
•
operation – occur when components fail or equipment is accidentally
disconnected during normal system operation
In either case, identifying the problem should be approached
systematically. A problem may have more than one cause. To isolate
the cause, a knowledge of Fiber Remote IPE operation is required. This
information can be found in
Nortel Communication Server 1000
Fiber Remote IPE Fundamentals
NN43021-554 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
"Product description" (page
93
15). Once the