Advertisement
Quick Links
Download this manual
See also:
Operating Manual
Model RW2HD
Model RWN2
This manual is considered to be part of the appliance and is to be given to the OWNER or
MANAGER of the restaurant, or to the person responsible for TRAINING OPERATORS of
this appliance. Additional manuals are available from your WELLS DEALER.
THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR
INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any
questions concerning installation, operation or maintenance of this equipment.
2M-303335
Rev. G
265 Hobson Street, Smithville, Tennessee 37166
IMPORTANT: DO NOT DISCARD THIS MANUAL
WELLS MANUFACTURING
telephone: 314-678-6314
fax: 314-781-2714
www.wells-mfg.com
DRAWER WARMERS
with THERMOSTATIC
OWNERS MANUAL
FREE STANDING
CONTROL
MODELS
RW1HD
RW2HD
RW3HD
RWN1
RWN2
RWN3
Includes
INSTALLATION
USE & CARE
EXPLODED VIEW
PARTS LIST
WIRING DIAGRAM
041
03/18
Advertisement
Related Manuals for Wells RW1HD
Summary of Contents for Wells RW1HD
- Page 1 Additional manuals are available from your WELLS DEALER. THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment.
- Page 2 Wells’ discretion have the parts replaced or codes, including incorrect gas or electrical connection. Wells is not liable repaired by Wells or a Wells-authorized service agency.
- Page 3 PARTS & SERVICE CUSTOMER SERVICE DATA INTRODUCTION Thank You for purchasing this Wells Manufacturing appliance. Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life.
- Page 4 FEATURES & OPERATING CONTROLS HUMITROL RACK DRAWER INSERT PAN AIR VENT CONTROL HEATING INDICATOR TEMPERATURE CONTROL POWER CORD ADJUSTABLE ROLLER CATCH DRAWER GASKET DRAWER STOP DRAWER ROLLER DRAWER SLIDE DRAWER DRAWER SLIDE CATCH DRAWER HEATING ROLLERS ELEMENT IL2929...
-
Page 5: Agency Listing Information
PRECAUTIONS AND GENERAL INFORMATION This appliance is intended for use in commercial establishments only. WARNING: ELECTRIC This appliance is intended to prepare food for human consumption. No SHOCK HAZARD other use is recommended or authorized by the manufacturer or its agents. - Page 6 INSTALLATION NOTE: DO NOT discard UNPACKING & INSPECTION the carton or other packing Carefully remove the appliance from the carton. Remove all protective materials until you have plastic film, packing materials and accessories from the Appliance inspected the appliance for before connecting electrical power or otherwise performing any hidden damage and tested installation procedure.
- Page 7 INSTALLATION (continued) ELECTRICAL WARNING: Refer to electrical specifications on page 1. Circuit must meet or SHOCK HAZARD exceed the amperage and wattage requirements listed. All servicing requiring access to non-insulated electrical components must 120 Volt units require a properly grounded NEMA 5-15R receptacle: be performed by a factory authorized technician.
- Page 8 The chart below is intended Moist heat with pans: as a guide ONLY. Your own experience with this This Wells warmer is designed to accommodate any appliance, type of foods combination of standard-size, steam table pans. and method of operation will Place a small amount of water in drawer pan.
- Page 9 OPERATION (continued) OPERATION CAUTION: HOT SURFACE Determine the type of food to be warmed. Refer to the chart on page 6 to determine the type of heat required. Exposed surfaces can be hot Set the air vent control for the type of heat, and rotate the to the touch and may cause thermostat knob to the temperature setting desired.
-
Page 10: Cleaning Instructions
CLEANING INSTRUCTIONS PRECAUTIONS: Turn control knob to OFF. CAUTION: Allow drawers to cool before proceeding. SHOCK HAZARD Remove drawer pans and Humitrol racks. FREQUENCY: Minimum - Daily Disconnect appliance from electric power before cleaning. TOOLS: Warm water and mild detergent Clean cloth or sponge CAUTION: HOT SURFACE... -
Page 11: Troubleshooting Suggestions
Plug warmer into appropriate receptacle No lights or heat (all Circuit breaker off or tripped Reset circuit breaker drawers) Contact an Authorized Wells Service Internal damage Agency for repairs. Temperature control not set Set for desired temperature. No heat (one drawer) - Page 12 MAINTENANCE INSTRUCTIONS (continued) ADJUSTMENTS AND LUBRICATION CAUTION: SHOCK HAZARD PRECAUTIONS: Turn control knob to OFF. Unplug warmer Allow drawers to cool before proceeding. Remove drawer pans and Humitrol racks Disconnect appliance from electric power before cleaning. FREQUENCY: Minimum - monthly. Every 2 weeks recommended.
- Page 13 WIRING DIAGRAM...
- Page 14 EXPLODED VIEW & PARTS LIST: RW1HD, RW2HD, RW3HD DRAWER ASSEMBLY - COMMON TO ALL HD VERSIONS CAVITY and CABINET INERIOR - COMMON TO ALL HD VERSIONS (optional thermometer) IL2251b...
- Page 15 EXPLODED VIEW & PARTS LIST RW1HD, RW2HD, RW3HD, DRAWER WARMER Fig No Part No. Description WS-20624 RACK HUMITROL RWS (OPTIONAL) C8-46840 PAN INSERT DRAWER RWHD WS-67096 DRAWER ASSY KIT RWHD C8-32112 HANDLE RW DRAWER SRW320 WS-51796 KNOB SQUARE ROLL WARMER VENT...
- Page 16 EXPLODED VIEW & PARTS LIST: RWN1, RWN2, RWN3 DRAWER ASSEMBLY - COMMON TO ALL “NARROW” VERSION RWN-SERIES DRAWERS CAVITY and CABINET INTERIOR - COMMON TO ALL “NARROW” VERSION OPTIONAL THERMOMETER WELLS IL2093c...
- Page 17 EXPLODED VIEW & PARTS LIST RWN1, RWN2, RWN3, DRAWER WARMER Fig No Part No. Description WS-20624 RACK HUMITROL RWS (OPTIONAL) C8-49252 INSERT DRAWER RWN WS-69244 DRAWER ASSY RWN WS-69248 HANDLE DRWR RWN WS-51796 KNOB SQUARE ROLL WARMER VENT C8-49251 SLIDE VENT ASSY RWN 2C-35530 SCREW, 8-32 X 3/8 PH, RD-EACH 2C-35565...
- Page 18 NOTES...
-
Page 19: Customer Service Data
C8-49252 or to order factory authorized replacement parts, contact LEG KIT, 4” PLASTIC (SET OF 4) WS-20314 your Wells authorized service LEG KIT, 4” METAL (SET OF 4) WS-20563 agency, or call: LEG KIT, 6” METAL (SET OF 4) WS-21607 CASTER KIT 10”... - Page 20 WELLS MANUFACTURING 265 Hobson Street, Smithville, Tennessee 37166 telephone: 314-678-6314 fax: 314-781-2714 www.wells-mfg.com...