Advertisement
INSTALLATION
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested
it for proper operation.
Refer to SHIPPING
DAMAGE CLAIM
PROCEDURE on the inside
front cover of this manual.
WARNING:
RISK OF
INJURY
Installation procedures
must be performed by a
qualified technician with full
knowledge of all applicable
electrical and plumbing
codes. Failure can result in
personal injury and property
damage.
MOUNTS INTO
THREADED
HOLES IN
WARMER
FRAME
TURN BOTTOM
PORTION TO
ADJUST
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all protective
plastic film, packing materials and accessories from the Appliance
before connecting electrical power or otherwise performing any
installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before discarding
packing materials. Store all accessories in a convenient place for later
use.
COMPONENTS
1 - 3 ea. DRAWERS (qty. depends on model)
1 - 3 ea. HUMITROL RACKS (if ordered with unit)
SETUP
Install adjustable legs or optional casters, one on each corner of the
appliance, in the holes provided.
Verify that the unit sits firmly on ALL FOUR legs. With a spirit level,
check that the appliance is level front-to-back and side-to-side. With
the adjustable legs, adjust as required to level the appliance. All four
legs must be adjusted to firmly contact the floor in order to prevent
tipping.
If drawers were removed during installation, install drawer(s) in unit:
a.
Check the roller catch inside the cabinet. The spring-loaded roller
arm must be extended.
b.
With the front of the drawer assembly tipped downward,
engage the roller on the drawer with the cabinet drawer slide.
c.
Raise the drawer to the horizontal position until the drawer-
mounted slide engages the dual roller assembly on the cabinet.
d.
Slide the drawer in until the catch engages. The drawer should
remain tightly closed.
IL2926
e.
Slide the drawer out. The drawer stop should prevent the
drawer from coming all of the way out.
f.
Install drawer insert pans.
Avoid storing flammable or combustible materials in, on or near the
appliance.
4
Advertisement
