Xerox MF Series Technical Document page 65

D8
SUBJECT: C
Tools
• Phillips screwdriver.
Preliminary steps
• Remove the top cover (worksheet D3) and the control panel/chassis - printer (worksheet D5).
Disassembly
• Disconnect the grounding lugs located under the top cover.
• Press the control panel opening lever.
• Press outwards on the latch and release the stop.
• Free the control panel flat cable.
• With the control panel assembly placed on a work surface, take hold of the control panel and
lift the chassis towards the right to free the left-hand joint, then push it forward to free the right-
hand joint. Disconnect the control panel grounding wire and remove the chassis.
Control panel
Right joint
• Free the control panel flat cable from the cable guide and remove it.
Repose
• Unpack and visually inspect the new parts.
• Connect the grounding wire to the control panel. Join the control panel and chassis at the right-
hand joint, then position them at right angles to each other, and join them at the left-hand joint.
• Press on the latch and close the control panel, letting the stop lock behind the latch.
- 17 -
- E
ONTROL PANEL
PANEL FLAT CABLE
QUIPPED CONTROL PANEL
- C
HASSIS
Left joint
Chassis
MG 252 787 467 - A
- C
ONTROL