Xerox MF Series Technical Document page 62

D5
SUBJECT: C
Tools
• Phillips screwdriver.
• Flat screwdriver.
Preliminary steps
• Remove the CPU board (worksheet D4).
Disassembly
• Open the control panel by means of its lever, remove the two mounting screws.
Mounting
screws
• Close the control panel and open the scanner chassis by means of its lever. Hold the scanner
chassis/control panel, and use a flat screwdriver as a lever in the two notches indicated by the
arrows in the figure above to loosen the fixing clips and remove the scanner chassis/control
panel.
Assembly
• Unpack and visually inspect the new parts.
• Put the control panel chassis in place. Open the control panel by means of its lever.
• Screw in and tighten the two mounting screws. Close the control panel.
• See worksheet D4 for the connection of the flat cables and the motor drive supply.
- 14 -
/ S
ONTROL PANEL CANNER CHASSIS
MG 252 787 467 - A
- P
RINTER