Xerox MF Series Technical Document page 59

D3
SUBJECT: C
Tools
• Phillips screwdriver (small size).
• Flat screwdriver.
Preliminary steps
Attention - The active surface of the CIS is fragile and light-sensitive. Take care to protect it and to
expose it to light as little as possible during the operation.
Disassembly
• Stand at the back of the fax.
• Press the control panel opening lever.
• Use a flat screwdriver as a lever at the four locations shown on the figure above to unclip and
remove the top cover of the control panel, then close the chassis again.
• Stand in front of the fax.
• Lift the control panel at its upper right-hand corner (A), hold it and apply a medium amount of
pressure halfway down its side (B). First free the right-hand side of the control panel by push-
ing downwards (C).
- 11 -
ONTROL PANEL
- G
PLAY LASS
Top cover fixing clips
Control panel
D
E
F
- C
IRCUIT BOARD
- T
OP COVER WITH LOUDSPEAKER
A
B
C
MG 252 787 467 - A
- E - D
LASTOMER IS
-