Xerox MF Series Technical Document page 155

<Installation Procedures>
1. Take out the Fusing Unit and cushioning materials.
B
C
A
6. Reinstall the Fusing Unit protective metal bracket.
2. Connect connector A.
3. Mount the Fusing Unit in the printer and secure it
in position by tightening the two screws.
4. Connect connectors B and C.
NOTE
• When installing the Fusing Unit, route the harness
as shown in the illustration and make sure that no
4136E017AC
part of the harness is wedged between the Fusing
Unit and printer.
5. Reinstall the Exit Cover.
E-9