Step 2: Set the Y-axis Origin (Call Up the A-axis Center)
Once detection of the A-axis center is finished, setting the Y-axis origin is possible. We recommend performing this operation
every time before you start cutting in order to verify that the Y-axis origin is at the A-axis center.
Procedure
Continue by proceeding with "4-3 Setting the Z-axis Origin."
4-2 Setting the Y-axis Origin
Close the spindle cover.
In VPanel, click the [Base Point] icon.
If you're in the NC-code mode, then
select the workpiece coordinate sys-
tem you're using.
Select [Y Origin].
Click [Apply].
Chapter 4 Setting the Origins
47