Overview Of The Installation Porcedure - Roland MODELA Pro II ZCL-540 User Manual

Overview of the installation Porcedure

This in an overview of the installation procedure. For the specific steps required to install this unit, see the following section.
Set Up the Modeling machine
Finish installing the modeling machine, installing and setting up the program and other software, and connecting the
modeling machine to the computer. Also, finish installing the optionally available T-slot table at this time.
Install the ATC Unit
I
f you intend to use this unit in combination with an ATC unit, then install the ATC unit first.
Install the Rotary Axis Unit
Install the unit.
Important Notes on Installation Operations
 Before installing, clean away any cutting waste and any soiling on the installation surface. Any foreign
matter that becomes caught between components may reduce accuracy.
 For several parts, the installation location is determined by butting the part flush against a surface.
Because accuracy can be reduced by improper contact when doing this, carry out such procedures
especially carefully.
About Use in Combination with an ATC Unit
If you intend to use this unit in combination with an ATC unit, then install the ATC unit first, before you install this unit. If this
unit is already installed on the machine, then it must first be removed.
Also, the ATC unit includes a Z-origin sensor as well, but it is not used, so remove it. When you're using this unit in combina-
tion with an ATC unit, attach only the Z-origin sensor for this unit.
About VPanel Settings
VPanel automatically detects this unit when it is installed. You don't need to make any special settings.
2-1 Before Installing
Chapter 2 Installation 25