2-2 Step 1: Install the Unit
For a Standard Table
The installation method differs depending on the type of table attached. If you're using a modeling machine equipped with
a standard table, then use this method to install.
Procedure
Gently turn the workpiece chuck by hand until the installation hole can be seen.
Slide the T-slot nut into the groove.
Attach the drive unit.
T-slot nut
26
Chapter 2 Installation
Cap screws
(M8 x 20 mm)
Cap screw
(M8 x 20 mm)
Prepare the modeling machine.
Remove any tools.
Use manual feed to move the table
toward the front.
Shut down the modeling machine
and disconnect the power cable.
WARNING: Be sure to disconnect
the power cable. Failure to do so
may result in danger of injury.
Install the base plate.
Stopper
Butt this flush
against the edge of
the plates.
Tab
Butt this flush at the
front.