Table of Contents
Advertisement
im Vertrieb von
Installation, cont'd
Through-desk mounting
Mount the PIP through a desk or podium as follows:
1.
2.
3.
Figure 2-2 — Through desk mounting a PIP
4.
5.
6.
www.camboard.de
2-4
PIP 422 and PIP 444 Picture-in-Picture Processors • Installation
CAMBOARD Electronics
Remove the feet from the underside of the PIP, if installed.
Attach the supplied mounting brackets to the processor with the machine
screws provided (figure 2-1).
Cut the proper sized hole in the mounting surface (figure 2-2).
Hold the processor with the attached brackets against the underside of the
table or other furniture. Mark the location of the screw holes of the bracket on
the mounting surface.
Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep in the mounting
surface at the marked screw locations.
Insert four #8 wood screws through the bracket and into the four pilot holes.
Tighten all four screws to secure the processor in place.
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de
Advertisement
Table of Contents
