© 2019 Avaya Inc. All rights reserved
•
Setup Wizard Enhancements
When a new Avaya XT Series endpoint is installed, a quick setup wizard is displayed to manually
configure some needed parameters (for instance GK address/E.164 or SIP Server address with
credentials), in addition to other user preferences like displayed endpoint name and UX language.
With this release, Avaya XT Series endpoints can be auto-configured, up and running, with
minimal user intervention.
Release Notes for Avaya XT Series
o
HD1 is selected as default.
o
Driver Mode is Automatic
Under HD1 camera config:
o
Check that the detected camera driver is XTSeries TC220 Camera. If the driver
mode was set as Manual, select this diver.
o
Check that the tracking is enabled. If the tracking is disabled, only the rightmost
camera will be used and can be controlled manually (for PTZ and presets). If the
tracking is enabled, manual PTZ and preset commands are ignored.
Important
•
The TC220 camera cannot be cascaded to other cameras in this release (Visca
cable connection from the first HD camera to the TC220 camera is not supported).
•
To use the TC220 camera as a second HD camera on XT7100, with autotracking
enabled, do the following:
o
Power the TC220 camera with its own power supply.
o
Assure that the autotracking is enabled in the camera. This is the default
when the camera is powered on.
o
Connect the TC220 to the HD2 camera input of XT7100.
o
When the TC220 is used as second HD camera, it will not stop following the
active speaker when the camera is not selected, or the system is in standby.
What's New | 9