Enhancements - Avaya IX Room Systems XT Series Release Notes

© 2019 Avaya Inc. All rights reserved
Cloud Mode – Connected
[Q]What happens if I load factory defaults on a provisioned endpoint?
[A]Your endpoint will remember the Service Code inserted for Provisioning and will propose it
again (only the first 5 digits are needed). Just press "Next" in the initial wizard to have you're the
endpoint configured again with the same Avaya Equinox® Management.
[Q]How can I associate my endpoint to a different Management Server with auto provisioning?
[A]Ask your administrator to remove your endpoint from the Management Server and to add it to a
new Management Server. Once you received a new Service Code, load Factory defaults on your
endpoint. You will be prompted to insert the Service Code for the Management Server. Insert the
new one you received.
[Q]How can I associate my endpoint to a different Management Server manually?
[A]Ask your administrator to remove your endpoint from the first Management Server and to add it
to a new Management Server manually. You will be disconnected from the first server and
connected automatically to the second one.
[Q]How can I force my endpoint to forget the assigned Management Server Service ID?
[A]Configure your endpoint for "Local" mode with a manual IP empty address (0.0.0.0) or with a
different Management Server.
[Q]I have a valid service code for my endpoint, but the initial Wizard keeps saying that the
Management Server is not available...? What can I do?
[A]Check that your endpoint is connected to the network. Check that it received a valid IP address
and a valid DNS server address from the DHCP server on your network. Then connect to the
endpoint Web Server using any browser (see "Web Interface Management section") and browse
to
[W
EB
it is not reachable, your endpoint is not connected to the internet or the configured DNS is not
valid. If the above URL is reachable, check that the FQDN configured in
reachable.
[Q]What happens if my endpoint is managed by Equinox Management and I run the Quick Setup
Wizard and choose an Equinox Environment different from the one in which my endpoint is
managed, or I change the settings manually?
[A] After a while, Equinox Management will detect the changes and show an alert for your
endpoint in the dashboard. A similar alert is displayed if you change some settings manually after
your endpoint is provisioned. It is possible for the Equinox Management administrator to change
the endpoint settings any time while the endpoint is managed.

Enhancements

This release introduces a few enhancements and fixings
•
•
•
Release Notes for Avaya XT Series
] D >N >P
IAGNOSTICS ETWORK ING
•
Added the possibility to choose as Home Screen Background the Calendar page and to
hide the Calendar Panel in Home page (only if the Calendar is enabled)
o
[G I] C > A
U ONFIGURE
o
[W ] A
EB DMINISTRATOR
Fixings for join meeting alerts and messages.
When making SIP direct calls to a destination that has been resolved with different IP
addresses, the system now tries to connect to the next IP address in case the call to the
previous one fails, as already available for H.323 calls. Moreover, the system tries all
available transport protocols, in this order:
If SIP "Outbound Transport Call" field is set to:
Ping "support.avaya.com" or a similar well-known web URL. If
.
> S >C
DVANCED YSTEM USTOMIZATION
S > S >C
ETTINGS YSTEM USTOMIZATION
is
Avaya Equinox® Management
What's New | 17