What's New; Setup Wizard Enhancements - Avaya IX Collaboration Unit CU360 Release Notes

© 2019 Avaya Inc. All rights reserved.

What's New

This section describes some features available in this software version 10.1.0.23 respect to
previous GA version 10.0.0122.
Please note that if you are familiar with the Avaya XT Series endpoints, most of the
functionalities and the configuration are the same. This document focuses on the specificity
of the product respect to the Avaya XT Series.

Setup Wizard Enhancements

When a new Avaya CU360 endpoint is installed, a quick setup wizard is displayed to
manually configure some needed parameters (for instance GK address/E.164 or SIP Server
address with credentials), in addition to other user preferences like displayed endpoint name
and UX language.
With this release, Avaya CU360 endpoints can be auto-configured, up and running, with
minimal user intervention.
In addition to manual setup, and to an automatic setup at first boot based on Equinox
Management Endpoint Auto-Provisioning feature available since previous release, this
release adds the possibility to easy configure the endpoint when part of an Equinox
Deployment with auto-configuration enabled based on DNS service discovery.
If your Equinox Deployment does not support this feature, you can still configure your
endpoint at first boot through Equinox Management (with a pre-provisioning or post
provisioning code), or any time manually.
At first boot, the user will see the below screen on the UX interface of the endpoint.
You can choose the preferred language for the device.
If no Ethernet cable is connected, you can also configure your Wi-Fi Network.
Initial Setup Wizard – Choose your Language
© 2015 Avaya Inc. All rights reserved. NDA Confidential, Use pursuant to your agreement.
Important
•
A license is not needed to enable or upgrade your product.
•
To configure your Wi-Fi, press Wi-Fi and select you network. See Network
Connectivity section for more details.
•
Once network connectivity is available, press Next.