Genie S-65 XC CE Operator's Manual Supplement page 11

First Edition • Third Printing
Updating the Machine Software.
Note: Access to the internet is required to
perform this procedure.
1 Click on the Hyperlink below or open an
internet browser and copy and paste or type
the link into the address bar and press enter.
http://firmware.genielift.com/
http://firmware.genielift.com/
2 Select the model that is appropriate for your
machine under Machine Model. Select
Search.
3 Select the appropriate Firmware File to be
updated. Select I Accept. Save or print a copy
of the ALC-600 Software Update
instructions 1295343GT.
4 Follow the instructions to update the machine
software in the following order.
 Checking the File System Format of a USB
Flash Drive
 Firmware Site Download
 How to Enter ALC-600 Software Update
Mode
 Model Configuration and Region Settings
(Note: Do not perform steps 11 and 12.)
5 Push in the red Emergency Stop button to the
off position.
Part No. 1295772GT
Selecting the Platform Option.
The appropriate platform option must be
selected when installing or removing the
4m platform.
DANGER
1 Press and hold buttons 2 and 3. Pull out the
red Emergency Stop button to the on position.
2 You will be prompted for a password.
Enter 3 - 3 - 2 - 4.
3 Press the Settings button to access the
settings menu.
Note: There will be a delay while the menu is being
loaded on the display screen.
4 Select Options. Press OK.
5 Select Platform. Press OK.
6 Select the appropriate platform. Press OK.
 Standard
 4m / 13 ft
4m Platform
Operator's Manual Supplement
Software Update
Tip-over hazard. Not selecting
the appropriate platform option
will result in death or serious
injury.
11