CL3/CL1
A-9. DA Circuit Board
(Time required: About 17 minutes)
A-9-1. Open the control panel U7 assembly and secure with
the service stays. (See procedure 1)
A-9-2. Remove the rear upper U7 sub assembly.
(See procedure A-1)
A-9-3. Remove the JK sheet assembly. (See procedure A-6)
A-9-4. Remove the HAAD circuit board.
(See procedure A-7)
A-9-5. Remove the two (2) screws marked [920]. The FFC
angle FR can then be removed. (Photo 14)
A-9-6. Remove the sixteen (16) screws marked [730] and the
two (2) screws marked [740]. The DA circuit board
can then be removed. (Photo 14)
[740]
56
FFC ANGLE FR
(FFC アングル FR)
[920]
[730]
[730]
Photo 14 ( 写真 14)
A-9. DA シート
(所要時間:約 17 分)
A-9-1. コンパネ U7 Ass y を開けて、サービスステイで固
定します。 (1 項参照)
A-9-2. リア上パネ U7 サブ Ass y を外します。 (A-1 項参照)
A-9-3. JK シート Ass y を外します。 (A-6 項参照)
A-9-4. HAAD シ−トを外します。 (A-7 項参照)
A-9-5. [920] のネジ 2 本を外して、FFC アングル FR を外
します。 (写真 14)
A-9-6. [730] の ネ ジ 16 本 と [740] の ネ ジ 2 本 を 外 し て、
DA シートを外します。 (写真 14)
DA
[920]
[730]
[740]