Port Configuration; Setting Port Id; Viewing Link State - 3Com TR User Manual

Port Configuration
Port parameters can also be set from the LCD console
on the Switch 2000 TR front panel. If you have made
settings using the VT100 interface, those settings will
be reflected in the LCD console. Refer to Chapter 3
for more information on navigating the LCD console
and the LCD console map.
The screens are circular, meaning that you can access
them by scrolling either up or down. For the sake of
simplicity, these instructions use only the Down Arrow
to move through the screens.
You can set these parameters using the LCD console:
Port ID
Link State
Port State
Speed Mode
Personality
Refer to the LCD Console menu map (Figure 3-9) for
more information.
Switch 2000 TR
ENTER
> Port
Figure 5-1 LCD Console Port Menu
Port ID Port ID
Personality Personality
ENTER
Speed
Speed
Port State
Port State
Link State Link State
Link State

Setting Port ID

From the Switch 2000 TR>Unit Id # LCD banner, pro-
ceed as follows:
Press [Enter].
1
Switch 2000 TR >Unit appears.
Press [Down Arrow] until Switch 2000 TR >Port
2
appears.
Press Enter.
3
Port >Port ID appears with the port number. Initially
the port number shows Port 1.
Press [Enter].
4
Use the [Up or Down Arrow] to scroll the ports and
5
select the port you wish to configure.
Press [Enter] to select the port.
6
Port >Port ID appears, and the port number reflects
the port number you chose in step 5.

Viewing Link State

Link State reflects the current state of the port and
cannot be changed. Refer to "Port Statistics in
Chapter 6 for definitions of the states.
From the Switch 2000 TR>Unit Id # LCD banner, pro-
ceed as follows:
Press [Enter].
1
Switch 2000 TR >Unit appears.
Press [Down Arrow] until Switch 2000 TR >Port
2
appears.
Press Enter.
3
Port Configuration 5-3