Table of Contents
Advertisement
2
G
ETTING
This chapter describes the installation and setup pro-
cedures for the Switch 2000 TR:
Important Safety Information
Positioning the Switch 2000 TR
Installing the Slide-in Modules
Installing the Switch 2000 TR
Connecting Redundant Power System
Connecting to the Serial Port
Device Defaults
S
TARTED
Important Safety Information
NOTE:
Warnings contain directions that you must
follow for your personal safety. Follow all instructions
carefully. Please read the following safety information
before installing the Switch 2000 TR.
Installation or removal of any add-in module or
cable must be performed by qualified personnel
only.
The Switch 2000 TR must be attached to a
grounded power source.
The power cord must comply with the standards of
the country in which the Switch 2000 TR is to be
installed.
For USA and Canada:
The cord must be UL-approved and CSA certi-
fied.
The minimum specifications for the flexible
cord:
No. 18 AWG
Type SV or SJ
3-conductor
The cord must have a rated current capacity of
at least 10 Amps.
Advertisement
Table of Contents
