Travis Industries 36 CF Quick Start Manual page 2

36 CF Installation
1 Remove the glass frame, logs, and grate (see installation manual for details).
2 Install the firebacks following the directions below.
Replace the clip to secure the
side fireback (both sides).
e
While holding the rear firebacks in
place, slide the side firebacks
between the burner and side wall of
the firebox. The side firebacks hold
the back firebacks in place.
3 Restore the fireplace to the correct configuration.
Page 2 of 4
36 CF / 1080 CF Firebacks
Two-Sided (Brick or Herringbone) Arched 96100166 – Rectangular 96100172
Two-Sided (Diamond or Stucco) Arched 96100168 – Rectangular 96100174
Whidbey Rock Creek – 96100252
Remove the clip and screw located on the firebox
ceiling near the front (both sides).
b
Place the floor firebacks in the gap in
front of the burner. Bend the 3 tabs
on the burner down to secure the
floor firebacks.
d
Constitution Basket Weave / Quilt - 96100175
a
Left Floor
Fireback
9/15/08
c
Place the rear firebacks in
place. Note how the lower
fireback rests on the ledge
at the back of the firebox.
Travis Industries, Inc.