Configure Snmp Traps - Avaya S8700 Installing Manual

34
Configure Media Server 1
1 Under Diagnostics click Test Server LEDs to test the media server LEDs.
2 Observe the Active/Standby and U2 LEDs on the front of the media server and the
transmit LED on the duplication card on the back of the media server to ensure they are
blinking. The blinking stops after about a minute. See
page 215

Configure SNMP Traps

The following administration uses the computer used to access media server 1 and uses the
media server Web interface.
NOTE:
Configure trap destinations only if the customer's network administrator wants alarm
notification.
Refer to the filled-out job aid entitled Pre-Installation Network Planning Forms—S8700 Media
Server for host names, IP addresses, and community strings assigned to the UPSs and Ethernet
switch.
1 Under SNMP click Configure Trap Destinations to administer the simple network
management protocol (SNMP).
for more specific information.
October 2002
''S8700 Media Server LEDs'' on