Table of Contents
Advertisement
Maintenance and servicing
10.3 Installing software
Procedure
1. Isolate the device from mains and switch the monitor off.
Caution
Damage to the device!
Ensure that the device and the monitor are switched off.
2. Plug the monitor cable into the VGA socket.
3. Screw the monitor cable plug tight.
4. Connect the monitor cable to the monitor.
5. Connect the device to the mains again.
6. Switch on the device and the monitor.
7. When the operating system starts, press the <F5> key.
8. In the dialog that appears, select "640 x 480" as the resolution for the VGA mode.
The use of the monitor is limited with this resolution.
10.3
Installing software
10.3
10.3.1
Overview
Introduction
Restart the device systematically after exchanging the hard disk. Or reinstall the software as
required.
Caution
Do not turn off the device during the installation of software. Otherwise parts of the software
which are necessary for trouble-free operation will be lost. For commissioning, use the
default settings in the BIOS as described in the "Detailed Descriptions" chapter under the
section "BIOS Setup", "BIOS Setup Default Settings."
Note
The supplied drivers and applications have been tested for the system and released for this
device. No warranty can be provided for other software.
10-26
Operating Instructions, Edition 10/2004, A5E00339979-01
Panel PC IL 77
Advertisement
Table of Contents
