Table of Contents
Advertisement
Installation
4.3 Dimensions
Requirements
The installation cut-out has been made.
Procedure
1. Please follow the mounting guidelines.
2. Drill suitable holes at the prepared installation cut-out in accordance with the
specifications for L4 and L5, as shown in the installation cut-out in the dimension
diagrams.
3. Carefully drill the respective holes in the control unit at the designated location (1) from
the rear.
Figure 4-2
4. Working from the front, insert the HMI device into the installation cut-out.
5. Secure the control unit by inserting suitable screws through the holes and attaching nuts.
4.3
Dimensions
4.3
The mounting depth increases by 28 mm when a CD-ROM drive is installed in the device.
Refer to the dimension diagrams in the "Specifications" section for the exact measurements.
4-2
Designated location for holes on the control unit
Operating Instructions, Edition 10/2004, A5E00339979-01
Panel PC IL 77
Advertisement
Table of Contents
