Table of Contents
Advertisement
Options
17.1.1
Installing the Direct Key Module
A Touch Panel can accommodate either a direct key module or a control panel
interface (see section 17.2). The procedure for installing a direct key module is
as follows:
1. Place the front panel of the Touch Panel on a workbench.
Caution
!
2. Release the two pop rivets
Figure 17-1 Removing the cover (example TP37)
17-2
Make sure that the Touch Panel is disconnected from the voltage supply.
Always follow the ESD guidelines in the Appendix when working on open
devices.
in an example of the TP37, from the rear panel of the Touch Panel.
·
and then the cover · indicated in figure 17-1,
TP27, TP37 Equipment Manual
Release 01/00
Advertisement
Table of Contents
