Table of Contents
Advertisement
Commissioning
6.2 Switching on the device
6.2
Switching on the device
6.2
Procedure
1. Plug the power plug of the supplied power supply cable in the AC/DC power supply
connector of the device.
2. Screw-mount the power plug lock (1).
Figure 6-1
3. Interlock the power plug as shown
4. Plug the power supply cable into a socket with a grounded protective conductor.
5. Switch on the power switch of the device.
The device starts up and boots.
Self test
After connection to the power supply, the device performs a self test. During the self test,
the message "Press <F2> to enter SETUP" appears briefly.
When the self test is finished, the operating system will be loaded.
6.3
Setting up the Microsoft Windows operating system
6.3
Introduction
The setup wizard appears immediately following the startup of the device. The wizard is
used to set the parameters of the operating system.
Note
The dialogs of the setup wizards differ slightly in some places for the Windows 2000 and
Windows XP operating systems.
In order to change to the next dialog, click on the ">>" button. In order to change the entry in
the previous dialog, click on the "<<" button.
Procedure
1. Accept the Microsoft licensing agreement.
2. Perform the regional settings of the operating system.
3. Enter the company names and user names.
4. If his PC name is already in use as you attempt to connect the device to a network: Enter
a new PC name for identification.
The operating system will restart automatically.
The system settings will be updated and the desktop will be set up. The setup of the
operating system is complete.
6-2
Interlock the power plug
Operating Instructions, Edition 10/2004, A5E00339979-01
Panel PC IL 77
Advertisement
Table of Contents
