588
7-3. Do-it-yourself maintenance
1
Park the vehicle in a safe
place, wait for approximately
20 minutes, and then start
the hybrid system.
2
Press
or
control switches on the steer-
ing wheel and select
3
Press
or
control switches and select
"Vehicle Settings", and then
press
.
4
Press
or
control switches and select
"TPWS", and then press
5
Press
or
control switches and select
"Change Wheel". Then press
and hold
until the tire
pressure warning light starts
slowly blinking 3 times.
The change wheel set mode is acti-
vated and registration is started.
Vehicles with a tire inflation pres-
sure display function only:
Then a message will be displayed
on the multi-information display.
When registration is being per-
formed, the tire pressure warning
light will blink for approximately 1
minute then illuminate and "--" will
be displayed for the inflation pres-
sure of each tire on the multi-infor-
mation display.
of the meter
.
of the meter
6
of the meter
When registration is completed, the
tire pressure warning light will go off
and the inflation pressure of each
.
tire will be displayed on the multi-
information display.
of the meter
Even if the vehicle is not driven at
approximately 25 mph (40 km/h) or
more, registration can be com-
pleted by driving for a long time.
However, if registration does not
complete after driving for 1 hour or
more, perform the procedure again
from the beginning.
7
■
When registering ID codes
●
ID code registration is performed
while driving at a vehicle speed of
approximately 25 mph (40 km/h)
or more.
●
Before performing ID code regis-
tration, make sure that no wheels
with tire pressure warning valve
and transmitters installed are near
the vehicle.
●
Make sure to initialize the tire
pressure warning system after
registering the ID codes. If the
system is initialized before regis-
tering the ID codes, the initialized
values will be invalid.
Drive the vehicle at approxi-
mately 25mph (40 km/h) or
more for approximately 10 to
30 minutes.
Initialize the tire pressure
warning system. (P.584)