Toyota RAV 4 2019 Manual page 549

®
 HomeLink indicator light illu-
minates: Programming of a
fixed code device has com-
pleted. The garage door or
other device should operate
when a HomeLink
pressed and released.
®
 HomeLink indicator light
flashes rapidly: The garage
door opener or other device is
equipped with a rolling code.
To complete programming,
firmly press and hold the
®
HomeLink button for 2 sec-
onds then release it.
 If the garage door or other
device does not operate, pro-
ceed to "Programming a roll-
ing code system".
5
Repeat the steps above to
program another device for
any of the remaining Home-
®
Link buttons.
Programming a rolling code
■
system
Two or more people may be
needed to complete rolling code
programming.
1
Locate the "Learn" or "Smart"
button on the garage door
opener motor in the garage.
This button can usually be found
where the hanging antenna wire is
attached to the unit. The name and
color of the button may vary by
manufacturer. Refer to the owner's
manual supplied with the garage
6-4. Using the other interior features
door opener motor for details.
®
button is
2
Press and release the
"Learn" or "Smart" button.
Perform
performing 2.
3
Press and hold the desired
HomeLink
vehicle) for 2 seconds and
release it. Repeat this
sequence
(press/hold/release) up to 3
times to complete program-
ming.
If the garage door opener
motor operates when the
HomeLink
pressed, the garage door
opener motor recognizes the
HomeLink
3
within 30 seconds after
®
button (inside the
®
button is
®
signal.
549
6