Table of Contents
Advertisement
WARNING
HIGH
PRESSURE SPRAY CAN CAUSE SERIOUS INJURY.
FOR PROFESSIONAL USE ONLY.
OBSERVE ALL WARNINGS.
Read and understand all
instruction
manuals before operating
equipment.
INJECTION
HAZARDi
Do not
use
chemicals or agents which are not
compatible with Buna-N and PVC or neoprene cover of
Fluids under high pressure from
spray or leaks can
hose.
penetrate the skin and cause extremely serious injury,
including the
need for amputation.
Do not leave a pressurized unit unattended. Shut off the
unit and relieve Dressure before leaving.
NEVER point the spray gun at anyone or any part of the
body.
FIRE
NEVER put hand or fingers over the spray tip.
Do not spray flammable liquids. Do not operate the unit
where combustible fumes or dust may be present.
NEVER try
to
stop or deflect leaks with your hand or
body.
GENERAL
MEDICAL TREATMENT:
NEVER run the unit with the belt guard removed. Keep
clear of moving parts when the unit
is
run,ning.
If any fluid appears to penetrate your skin, get
EMERGENCY MEDICAL CARE AT ONCE.
Observe detergent manufacturer's safety precautions.
DO
NOT TREAT AS A SIMPLE CUT.
Avoid getting detergent or other liquids in your eyes.
Follow the directions on the container regarding
treatment instructions have your doctor call the
Tell the doctor exactly what fluid was injected. For
contact with eyes, nose, and skin, breathing fumes, etc.
Always wear full goggles to protect your eyes from the
NATIONAL POISON CENTER NETWORK
spray as well as any debris dislodged by the spray. If
(41
2)
681 -6669
necessary, wear gloves
or
other protective
clothing.
If
antidotes or treatment are recommended. be prepared
AVOID
COMPONENT
RUPTURE
to use them.
pressure in the pump, hose and gun until you relieve
it
Even after you shut off the electric motor, there is high
by triggering the gun. So before removing the spray.tip
or servicing the unit, always shut
off the unit andtrigger
the gun to release pressure.
components
will withstand the pressure developed.
Be sure that.. all accessory items and system
NEVER exceed the pressure rating of anycomponent in
system. NEVER alter or modify
equipment-your
personal safely, as well as the function
of the
equipment, is at stake.
DON7 spray toxic chemicals such as insecticide
or
weed killer.
This unit has a 3-prong grounding plug to protect you
from electric shock. Be sure to plug the unit into
a
properly grounded outlet that will accept the 3-prong
plug. Do
not remove the thirdprong.
The green wire of the electric cord is connected to the
are connected to the motor
switch for
grounding
unit chassis and motor frame and the other two wires
continuity.
Before each
use, check hose for weak, worn or
ALWAYS CHECK to be sure the switch is
OFF
and all
damaged conditions caused by traffic, sharp corners,
lines are clear of moving parts before plugging in the
pinching or kinking. Tighten all fluid
connections
power cord.
securely before each use. Replace any damaged hose.
IMPORTANT
United States Government safety standards have been adopted under the Occupational Safety and Health Act.
These standards-particularly
the General Standards, Part
1910,
and the Construction Standards, Part
1926
-
r .
should be consulted
in connection with your use of airless spray equipment.
2
801-237
Advertisement
Table of Contents
