Table of Contents
Advertisement
Turning the Power ON/OFF
Turning the Power ON
Make sure that the SmartMedia™ is correctly loaded. (
Set the Power switch to [ON].
When the camera is turned ON, set the mode dial to the desired
mode. In the photography modes ([
the lens extends from the camera body. Remove the lens cap during
photography. When the camera is turned ON, the Auto Power OFF
function starts to work.
The default setting for the language display for this camera is
English. To match the language in your Instruction Manual with the
language in the camera, change the language display in the LCD
monitor. (
Page 113)
IMPORTANT
• If no operation is carried out for a fixed amount of time (default: about 1 minute), the power is turned
OFF to prevent battery wear. This is called "Auto Power OFF". To return to the normal state, either
change the mode dial or press the shutter down half way (
About the Auto Power OFF Function
Turning the Power OFF
Set the Power switch to [OFF].
This turns the power OFF.
Attach the lens cap when you are not using the camera.
], [
], [
] or [
]),
Page 41).
Additional Information, "AUTO POWER OFF (page 114)"
- 39 -
Page 32)
Advertisement
Table of Contents
