Introduction - Dremel 3D40 FLEX Operating/Safety Instructions Manual

DM 2610039151 10-18.qxp_3D40 10/8/18 10:34 AM Page 10
WIFI
X-Axis Guide Rails
Y-Axis Guide Rails
Z-Axis Guide Rails
Welcome to the world of Dremel Digilab. Our
mission is to mentor you through the 3D
building process and share best practices for
bringing your ideas to life.
3D building is a process that will involve
experimentation and persistence. Thankfully,
the Dremel experts are here to make your
job easier with online tips and live support.
Dremel 3D40 brings new functionality to
Dremel3D such as network connectivity and
remote printing. To get started with 3D40
follow the initial setup routine on the touch
screen.
Glossary of Terms
A local area wireless networking technology that allow electronic devices to
communicate.
A set of rails on either side of the extruder that allow a stepper motor to move the
extruder to the left or right side of the build area.
A set of rails on either side of the build area that allow a stepper motor to move the
extruder to the front or back of the build area.
A set of rails located at the back of the build area that allow a stepper motor to move
the build plate up or down.

Introduction

10
You can create a user profile by going to
www.digilab.dremel.com. Your profile gives
you access to high-quality models, support
and software downloads, and remote printing
services. Once setup and registration is
complete you are ready to start building.